Chernets M.V. Influence of straight bevel gear teeth hooking conditions on their contact strength.

Authors

  • М.В. Чернець

Abstract

The influence of conditions of straight bevel gear teeth contact, which is connected with number of teeth pairs, that are in the gearing, on the level of maximal contact pressures has been researched. Calculation has been conducted on the basis of equivalent cylindrical gear with front, medium and internal modules of conic gear. Contact pressures reach their maximal values at the internal teeth butt end. As the result of conducted researches there has been established, that according to standardized technique of contact teeth strength calculation, pressures level would be 1,48 times higher, than according to developed technique, which allows to take into account the parity of gearing.

References

1. Czernec M. V., Bereza V. V., Czernec J. M. Ocinka wplywu parametriv evolventnych konicznych peredacz na ich dovhovicznist ta znoszuvannja. Cz. 1. Prjamozubi peredaczi. Problemy trybologii, № 1, 2011. S 12 - 18.
2. Czernec M. V., Kielbinski J, Bereza V. V. Metod prohnoznoi ocinky znoszuvannia konicznych peredacz z kosymy zubamy. Problemy trybologii, № 4, 2009. S 6 - 13.
3. Huzenkov P. H. Detali maszyn, Wysszaja szkola, 1986. 359 s.

Published

2014-07-14

How to Cite

Чернець, М. (2014). Chernets M.V. Influence of straight bevel gear teeth hooking conditions on their contact strength. Problems of Tribology, 69(3), 109–113. Retrieved from https://tribology.khnu.km.ua/index.php/ProbTrib/article/view/173

Issue

Section

Articles