Dykha O.V., Velboy V.P., Gedzuk T.V. Results of wear tests of of the conical standards from Steel 45 in motor oil

Authors

  • О.В. Диха
  • В.П. Вельбой
  • Т.В. Гедзюк

Abstract

Presented the results of tribo tests on the wear of conical standards from hard-tempered steel on the geometrical chart of tests a «cone - three balls» with lubrication. The set influence of speed of sliding and contact pressure is on intensity of wear. By mathematical two factor model of wear and got as a result of tests of its parameters the built dependences of intensity wear from determinatives.

References

1. Kuksenkova L.I., Laptєva V.G., Kolmakov A.G., Ribakov L.M. Metody ispytanii na trenie i iznos: Sprav. Izd. M. Intermet Inzhiniring, 2001. 152 p/
2. GOST 9490−75. Materialy smazochnye zhidkie i plastichnye. Metod opredeleniya tribologi-cheskih svojstv na chetyrehsharikovoj mashine. M. Izd-vo standartov, 1980.
3. Dykha O.V., Gedzuk T.V. Rated and experimental modeling of tribological properties of construc-tional and lubri-cating materials, Problemi tribologії (Problems of Tribology). 2014. No 1. PP. 84-87.
4. Spravochnik metallista. V 5-ti t. T. 1. Izd. 3-e, pererab. Pod red. S. A. CHernavskogo i V. F. Reshchikova. M. Mashinostroenie, 1976, 768 s s il.

Downloads

Published

2014-05-26

How to Cite

Диха, О., Вельбой, В., & Гедзюк, Т. (2014). Dykha O.V., Velboy V.P., Gedzuk T.V. Results of wear tests of of the conical standards from Steel 45 in motor oil. Problems of Tribology, 72(2), 111–116. Retrieved from https://tribology.khnu.km.ua/index.php/ProbTrib/article/view/120

Issue

Vol. 72 No. 2 (2014)

Section

Articles

Most read articles by the same author(s)

<< < 1 2 3 > >>