The problem of modelling of testing of abrasive wear in area of forming of powder materials
Abstract
In this article is a short presentation concerning abrasion wear on moving parts pressing tools in the area of powdered metallurgy. Moreover is described an allocation choice device to optimize alternative material and a description of this alternative used with material 19 436. Presented also is a principle for a new machinery solution to carry out laboratory tests with varied materials. A description of a mathematically parallel action by simulation of abrasion wearing in presentation mechanism is listed.References
1. BLAŠKOVIČ, P. - BALLA, J. - DZIMKO, M. (1990): Tribology, Alfa Bratislava
2. BARYSZ, I. - ČILLÍK, L. - ŽIAČIK, A. - PFLIEGEL, M. (1995): Slide bearings,
EDIS ed. University of Žilina, Žilina
3. MORAVEC, J. (1999): Active wear of dies in service, DOKSEM Žilina
4. MORAVEC, J. (2000): Contribution to the problem of modelling of abrasive wear tests, Materials Engineering Vol. 7 No. 1, p. 35-42
5. MORAVEC, J. et al. (2008): Shaping machines, EDIS ed. University of Žilina, Žilina
ISBN 978-80-8070-812-2
6. BROZ, J. et al. (1983): Basic physical measurements, STPN Prague
7. SAND, F. et al. (1975): Material Science I / 2, Academia Prague
8. MORAVEC, J. et al. (2005): Verification of the appropriateness nitrided steel employed for components forming tools, Scientific conference with international participation Construction materials Trnava 22 June post on CD ISBN 80-227-2241-3
9. MORAVEC, J. (2006): A small guide Metal Forming, ed EDIS. University of Žilina, Žilina, 83 pages, ISBN 80-8070-599-2
2. BARYSZ, I. - ČILLÍK, L. - ŽIAČIK, A. - PFLIEGEL, M. (1995): Slide bearings,
EDIS ed. University of Žilina, Žilina
3. MORAVEC, J. (1999): Active wear of dies in service, DOKSEM Žilina
4. MORAVEC, J. (2000): Contribution to the problem of modelling of abrasive wear tests, Materials Engineering Vol. 7 No. 1, p. 35-42
5. MORAVEC, J. et al. (2008): Shaping machines, EDIS ed. University of Žilina, Žilina
ISBN 978-80-8070-812-2
6. BROZ, J. et al. (1983): Basic physical measurements, STPN Prague
7. SAND, F. et al. (1975): Material Science I / 2, Academia Prague
8. MORAVEC, J. et al. (2005): Verification of the appropriateness nitrided steel employed for components forming tools, Scientific conference with international participation Construction materials Trnava 22 June post on CD ISBN 80-227-2241-3
9. MORAVEC, J. (2006): A small guide Metal Forming, ed EDIS. University of Žilina, Žilina, 83 pages, ISBN 80-8070-599-2
Downloads
Published
2014-07-15
How to Cite
Moravec, J., & Bohušová, Z. (2014). The problem of modelling of testing of abrasive wear in area of forming of powder materials. Problems of Tribology, 64(2), 115–120. Retrieved from https://tribology.khnu.km.ua/index.php/ProbTrib/article/view/237
Issue
Section
Articles
