Vol. 90 No. 4 (2018)

Articles

• Justification of criteria for assessing the inertia of tribosystems

  В. А. Войтов, А. Ш. Бекиров, А. В. Войтов

  6-13

  • pdf (Русский)

• Technological options for improving the wear resistance of the knives of the chopping drum of the combine by electrical contact welding of coatings

  О.В. Дудан, Є.К. Cолових, Ю.В. Волков, С.Є. Катеринич, А.Є. Солових, Д.В. Шевченко

  14-21

  • pdf (Русский)

• A method of abrasive wear is for determination of superficsal energy of crystals

  В. І. Дворук

  22-31

  • pdf (Русский)

• Analysis of tribological properties and promising research of non-metallic sliding bearings

  O. В. Дыха, В. П. Вельбой, В. О. Дитинюк

  32-35

  • pdf (Русский)

• Development of macroreological model of strain relaxation in lubricating film on friction surface in the presence of fullerenes

  А. Г. Кравцов

  36-40

  • pdf (Русский)

• Influence of operating factors on lubrication mode and wear resistance of parts of diesel engines of cars

  О. В. Диха, В.В. Аулін, С.В. Лисенко, А.В. Гриньків

  41-53

  • pdf (Русский)

• Influence of the coefficient of mutual overlap on the processes of friction and wear of tribosystems of the car

  О.Л. Ляшук, А.Б. Гупка, М.Г. Левкович, В.В. Гупка

  54-59

  • pdf (Русский)

• Influence of fullerene containing oils on the physical and mechanical properties of the surface of the friction of joints of parts

  В.В. Аулін, О.Д. Деркач, С.В. Лисенко, А.В. Гриньків

  60-64

  • pdf (Русский)

• Influence of operating modes on wear of parts made of polymer-composite material

  В.В. Аулін, О.Д. Деркач, Д.О. Макаренко, А.В. Гриньків

  65-69

  • pdf (Русский)

• Modeling of working conditions and wear resistance of the vehicle's clutch shaft

  О.Ю. Рудик, В.О. Дитинюк, Н.М. Стебелецька

  70-79

  • pdf (Русский)

• The influence of termination of the getting on contact extent steel x12 at termination

  П.В. Каплун, В.А. Гончар, А.В. Паршенко

  80-84

  • pdf (Русский)

• Sheeting for pistons of an internal combustion engine of aviation ground equipment

  В.В. Варюхно, А.Г. Довгаль, О.М. Білякович, Л. В. Курбет, А.М. Савчук, Ю.О. Туриця

  85-90

  • pdf (Русский)

• The influence of rolling emulsion physical and chemical parameters on the energy consumption of tinplate continuous cold rolling mills

  В.В. Кухар, І.В. Кармазіна, А.Г. Присяжний

  92-100

  • pdf (Русский)