The effect of the gap between screw and cylinder on the operating characteristics injection molding machine

  • П.В. Матвіїшин

Abstract

The experiment also showed the dependence of the twister and the time of loading and damping different types of plastic on the size of clearance between the screw and the cylinder, determined critical data for the clearance between the screw and the cylinder for the plastic under study. The excess of critical data makes the quality of the product worse.

References

1. Pererabotka plastmas. Shvarc O., Jebeling F.-V., Furt B. pod. obshh. Red. A.D. Panimatchenko. SP.: Professija. 2005. 320 s.
2. Shvecov G.A., AlimovaD.U., Baryshnikova M.D. Tehnologija pererabotki plasticheskih mass. M.: Himija, 1988. 512 s.
3. Gladchenko A.N., Shevelja I.V. Reologija iznosostojkosti metallicheskih tribosistem. Hmel'nickij, TUP «Univer» .2001. 183 s
4. Zavgorodnij V.K., Kalinchev Je.L., MaramE.I. Lit'evye mashiny dlja termoplastov i reaktoplastov. V.K. Zavgorodnij. M., 1968. 374 s.
5. Znosostіjkіst' detalej ekstruderіv і termoplastavtomatіv v abrazivnomu seredovishhі: Kniga v dvoh chastinah. Pіd zagal'noju redakcієju V.G.Kapluna. HNU. 2014. 244s.
6. Kaplun V.G., Les'kiv V.D., Silina L.A., Volynskij B.S. Issledovaanie shneka termoplastavtomata na ustojchivost' s primeneniem JeVM.. Inf. Mater. AN USSR. K.: Nauk. Dumka, 1979. S. 26-27.
Published
2016-02-12
How to Cite
Матвіїшин, П. (2016). The effect of the gap between screw and cylinder on the operating characteristics injection molding machine. Problems of Tribology, 77(3), 93-97. Retrieved from http://tribology.khnu.km.ua/index.php/ProbTrib/article/view/471
Section
Articles